You are here

Configure the Mail Attributes Preferences

You can set the available values for each mail attribute field used on a project, and if the attribute field is mandatory.
  1. Click Setup.
  2. Click Preferences.
  3. Click the Project tab.
  4. Scroll down to Project-wide settings.
  5. Under Mail, uncheck the Use Defaults checkbox beside the first mail attribute.
Editing the default Mail attributes
  1. If required, mark this mail attribute as compulsory by checking the Make Attribute compulsory checkbox.
  2. Repeat these steps for all the mail attributes on your project.
  3. Click Save at the top of the page. 
Making the attribute compulsory, and clicking Save
  1. Then, click the Edit button for the first mail attribute.
  2. Enter the possible values for this attribute.
mail attribute list

You can add more than one value at the same time.

Add each new term on a new line.

  1. Click the Add link.
  2. Click OK in the confirmation message.
Add attributes

After you click the Add link your attribute values will be listed in the field below.

  1. Click the Save button.
  2. Click the Close button in the confirmation screen.
  3. Click the back button.
back button
  1. When you are finished click the Save button.

Next step

Now go on to the final step.

Any feedback?

Thanks. A ticket has been opened with the Support Central team.